Quemahoning Tunnel

The Quemahoning Tunnel may have never been built by the Pennsylvanina Turnpike Commission, but it still has a history unto itself. Originally planned to carry rail along the South Penn Railway, the tunnel never would not see any trains until 1909 when a small line named the Pittsburgh, Westmoreland & Somerset began utilizing it. The use was brief and by the end of 1916 the PW&S was no longer in operation and abandoned the facility. Twenty-some years later, the newly formed Pennsylvania Turnpike Commission considered using the abandoned tunnel, in fact it was shown on some original plans. However, the PTC decided against using it, and the tunnel remained empty.

The eastern portal of the Quemahoning Tunnel is easily accessible from the PA Turnpike. The portal is located at mile 106.3 along the westbound roadway. The tunnel is one of the many "What Could Have Been's?" of the Pennsylvania Turnpike. Below, Bill Symons shares photos taken in late Fall of 1986 of the eastern portal of the Quemahoning and how close it does sit from the highway.

Looking into the entrance of the eastern portal. (Bill Symons)

The entrance is slightly hidden from view to those traveling westbound. However, it does sit relatively close to the modern highway. (Bill Symons)

Site Navigation:

Return to the Pennsylvania Turnpike Collection Index

Comments

The 1915-era Teilman Bridge (the only known Concrete Pony Truss Bridge in California)

The Teilman Bridge is a semi-abandoned structure over Fresno Slough west of Burrell siding near the intersection of Elkhorn Avenue and Elkhorn Grade. This structure is the only known Concrete Pony Truss Bridge constructed in California and was designed by Ingvart Teilman. Teilman's Bridge would open in late 1915 when the Elkhorn Grade was the primary road between Fresno and Coalinga. The structure would be replaced in 1991 but was left standing as it carries pipelines over Fresno Slough. Part 1; the history of the Teilman Bridge In the early Twentieth Century the most direct highway between Fresno and Coalinga followed the Elkhorn Grade. The Elkhorn Grade began at Fresno Slough a short distance west of Burrell siding. From Fresno Slough the Elkhorn Grade followed a generally southwestern course through San Joaquin Valley into the Kettleman Hills towards Coalinga. The Elkhorn Grade can be seen on the 1914 C.F. Weber map of Fresno Coun...

Former California State Route 41 past Bates Station

When California State Route 41 was commissioned during August 1934 it was aligned along the then existing Fresno-Yosemite Road north of the San Joaquin River. Within the Sierra Nevada foothills of Madera County, the original highway alignment ran past Bates Station via what is now Madera County Road 209, part of eastern Road 406 and Road 207. Bates Station was a stage station plotted during the early 1880s at what was the intersection of the Coarsegold Road and Stockton-Los Angeles Road. The modern alignment bypassing Bates Station to the east would be reopened to traffic during late 1939. Part 1; the history of California State Route 41 past Bates Station Bates Station was featured as one of the many 1875-1899 Madera County era towns in the May 21, 1968, Madera Tribune . Post Office Service at Bates Station is noted to have been established on November 23, 1883 and ran continuously until October 31, 1903. The postal name was sourced...

The William Flinn (not Flynn) Highway - Pittsburgh's Misspelled Street

For decades if you traveled along PA Route 8 in Pittsburgh's North Hills suburbs, you would have noticed signs that read "William Flynn Highway" at every intersection. Even today, many businesses and residences have their addresses listed as XXXX William Flynn Highway. However, it's not William Flynn Highway, it is William FLINN Highway - and the gentleman who it is named for has a long and storied past in Pittsburgh's infrastructure history. William Flinn was born in England in 1851; however later that year, his family emigrated to the United States and would settle in Pittsburgh. A 10-year-old school dropout, Flinn grew interested in politics and would join the Allegheny County Republican Party in 1877 as a ward commissioner and a seat on the Board of Fire Commissioners. Flinn would serve in the Pennsylvania State House of Representatives and Senate from 1877 to 1902. (1) Flinn along with James J. Booth would found the Booth and Flinn construction firm ...

Gribblenation

Search This Blog